Eicon Networks 1530 - Manual (Page 23)

Setup 23
Step 8: Test WAN Access
Once you have made the required changes, test that you have access to the remote device using
your WAN application. You can also ping the remote device to which you are attempting to
connect.
Troubleshooting
If you cannot access the WAN:
• Check your configuration settings (see Step 4: Modify VHSI Settings on page 17). Verify
that your settings are consistent with those of your network provider.
• Verify that your TCP/IP settings are correct for your situation (DHCP client or static IP
address) and that you have restarted your computer. If you cannot access the ‘Log in’ page
again, follow the instructions and suggestions given in
Step 3: Log in to the Eicon 1530 on
page 15.
What’s Next?
• If you are using the Eicon 1530 over a LAN, see Adjusting LAN Settings (if required) on
page 24 to verify if you must modify other LAN settings.
• To learn more about your Eicon 1530, see Using your Eicon 1530 on page 28.