Eicon Networks 1530 - Manual (Page 134)

Command Line Interface 134
IP Filter Commands
NEXT
Makes the next IP filter the current context. You can then edit the filter.
PREVIOUS
Makes the previous IP filter the current context. You can then edit the filter.
SET IP FILTER filterNum
Makes the specified filter the active context. You can then edit the filter.
filterNum: Number of the IP filter.
SHOW IP FILTER
Display all IP filters for the current profile. In a Filter context, displays only those filters that
are defined for the current filter.
SET TYPE { ALL | UDP | TCP | SYN | ANYICMP | ICMP [type] }
Defines the type of data to which this filter applies.
ALL: Applies to all data.
UDP: Applies to UDP data only.
TCP: Applies to TCP data only (default).
SYN: Applies to TCP connection (SYN) data only.
ANYICMP: Applies to all ICMP data.
ICMP: Applies to specific ICMP data (as set by type)
type: ICMP type to filter.
ADD IP FILTER FilterNum
Adds a new IP filter to the list at the specified position. You can insert a filter at any point in the
list.
filternum: Position where the new filter should be added.
ENABLE FILTER
DISABLE FILTER
Enables/disables IP filters. In the Profile context, this applies to all filters defined for the
profile. In the Filter context, this applies only to filters defined for the current filter.
DELETE IP FILTER filterNum
Deletes the specified IP filter.
filterNum: Number of the IP filter to delete.