Eicon Networks 1530 - Manual (Page 151)

Command Line Interface 151
X.25 Commands
SET X25 VERSION {1984 | 1988}
Defines the version of the X.25 protocol to use.
1984: ITU recommendation 1984.
1988: ITU recommendation 1988.
ENABLE X25 TOANPI
DISABLE X25 TOANPI
Enables/disables support for TOA/NPI addressing. This parameter only applies if the X.25
version is set to 1988.
X.25 version is defined with SET X25 VERSION.
SET X25 ADDRESS localX25addr
Defines the X.25 DTE address assigned to the Eicon 1530.
Range: 0-15 digits.
SET X25 REMOTE x25addr
Defines the remote X.25 address the Eicon 1530 calls to establish the connection.
Range: 0-15 digits.
When the X.25 connection type is set to permanent (see SET X25 CONNTYPE), this
parameter defines the VC number used.
SET X25 COMPRESSION {NONE | EICON | BAY | CISCO }
Defines the type of compression used for X.25 traffic.
NONE: No compression.
EICON: Compression negotiation: CCP (Compression Control Protocol). Compression
algorithm: LZS-STAC. Check mode: LCB, Sequence number, and extended mode. Not
compatible with Cisco routers.
BAY: Compression negotiation: WCP. Compression algorithm: Magnalink.
Check mode: LCB.
Dictionary size: 8K or 32K.
CISCO: Compression negotiation: None. Compression algorithm: LZS-STAC. Not compatible
with Eicon mode.
SET X25 CONNTYPE {TWOWAY | INCOMING | PERMANENT }
Defines the type of connection that will be established with the remote device.
TWOWAY: Both the Eicon 1530 and remote device can initiate the connection.
INCOMING The remote device must initiate the connection.
PERMANENT: A PVC is permanently established between two destinations. No call setup is
required.