Eicon Networks 1530 - Manual (Page 113)

Command Line Interface 113
Profile Commands
ADD PROFILE { PPP | X25 | FRELAY } name
Creates a new profile.
PPP: Creates a new profile using PPP over the VHSI port.
X25: Creates a new profile using X.25 over the VHSI port.
FRELAY: Creates a new profile using Frame Relay over the VHSI port.
name: Name for this profile.
Note: With X.25 or Frame Relay, you can create up to eight profiles. For PPP, you can create only one
profile.
DELETE PROFILE name
Deletes the specified profile.
DIAL
Dials out using the current profile.
HANGUP
Hangs up the connection established by the current profile.
SET PROFILE NAME name
Changes the name of the current profile. The name must not contain spaces.
ENABLE PROFILE
DISABLE PROFILE
Enables/disables the current profile.
SHOW PROFILE [ALL]
Displays the configuration settings for the specified profile, or displays the configuration
settings for al profiles if ALL is specified. In ‘General’ context, it always displays the current
state for all profiles.