Eicon Networks 1530 - Manual (Page 107)

Command Line Interface 107
Overview
This section provides a description for all commands available for the Eicon 1530.
Accessing the CLI
To access the command line interface, use a telnet program (such as Telnet included with
Windows, or HyperTerminal) to telnet using the LAN IP address of your Eicon 1530. By
default this address is 192.168.1.1. For example, from within Windows, click ‘Start’, ‘Run’,
type in the following, then click ‘OK’.
telnet 192.168.1.1
A Telnet window should appear asking you for a password.
Notational Conventions
The section uses the following conventions:
Syntax Example Description
RESET UPPERCASE TYPE indicates keywords. The actual words
can be entered in either uppercase or lowercase.
[ /C n ] Items enclosed in square brackets are optional. You can
either include them or not. Do not enter the brackets. If the
items are separated by vertical bars, you must choose one of
the items. Enter only one item. Do not enter the vertical bar.
numHops Items in lowercase type are user-supplied input. Replace
these items with values appropriate to your system.
{ THIS | THAT } Two or more items enclosed in braces and separated by a
vertical bars means you must choose one item. Enter only
one item. Do not enter the vertical bar.