Eicon Networks 1530 - Manual (Page 143)

Command Line Interface 143
PPP Commands
ENABLE PPP ENCRYPTED
DISABLE PPP ENCRYPTED
Enables/disables encrypted password to be sent for authentication. If enabled, an encrypted
password is used. This can only be used if the remote supports CHAP authentication. If
disabled, unencrypted password is used and the remote can support either PAP or CHAP
authentication.
Default: Disabled.
ENABLE PPP AUTHENT
DISABLE PPP AUTHENT
Enables/disables password authentication. When enabled, the Eicon 1530 WAN Router will
authenticate the remote, using the username and password (encrypted/unencrypted) received
from the remote.
Default: Disabled (Outgoing), Enabled (Incoming).
SET PPP LPASSWORD localPassword
Defines the password used when replying to valid authentication requests.
Range: 0-31 alphanumeric characters (no spaces). Default: eicon.
SET PPP LNAME localName
Defines the name used when replying to valid authentication requests.
Range: 0-31 alphanumeric characters (no spaces). Default: eicon.
SET PPP RNAME remoteName
Defines the name the remote device must supply when authentication is requested by the
Eicon 1530.
Range: 0-31 characters, no spaces. Default: eicon.
SET PPP RPASSWORD remotePassword
Defines the password the remote device must supply when authentication is requested by the
Eicon 1530.
Range: 0-31 characters, no spaces. Default: eicon.
ENABLE PPP COMPRESSION
DISABLE PPP COMPRESSION
Enables/disables PPP compression. When enabled, one of the following standards is
automatically negotiated: Ascend, MPPC, MS-STAC, STAC 1, and STAC 3.
Default: Disabled.