Eicon Networks 1530 - Manual (Page 116)

Command Line Interface 116
SET DHCP DOMAIN domain
Defines the domain name returned in response to a DHCP request, when the DHCP server is
enabled.
Range: 0-31 characters, no spaces.
SHOW DHCP CONFIGURATION
Displays the setting of all DHCP related parameters.
SET DHCP SERVERADDR { PRIMARY | SECONDARY } DHCPaddr
Defines the address of the DHCP servers where DHCP requests are to be forwarded, when
DHCP relay is enabled.
Primary: The IP address that follows is for the primary DHCP server.
Secondary: The IP address that follows is for the secondary DHCP server.
DHCPaddr: IP address of the DHCP server.
SET DHCP MAXHOPS numHops
When a DHCP request is received with a hop count greater than the number specified, the
request is discarded. Only valid when DHCP is set to relay.
numHops: Maximum hop count supported for DHCP relay requests.
Range: 1-16.
Default: 4.
SET DHCP DELAY seconds
Defines how long to wait before relaying a DHCP request. Since DHCP requests and responses
are broadcast to all stations on a LAN, the Eicon 1530 must check that no other DHCP server
has responded to a DHCP request before the request is forwarded to the external network.
seconds: Number of seconds to wait before forwarding a DHCP request.
Range: 1-30 seconds.
Default: 4 seconds.
SHOW DHCP TRACE [memsize [framesize]]
Starts a DHCP trace, or displays an active DHCP trace.
memsize: RAM reserved to store the trace on the Eicon 1530.
Range: 1-63 KB. Default: 16 KB.
framesize: The number of characters to display in each frame.
STOP DHCP TRACE
Stops an active DHCP trace.