Eicon Networks 1530 - Manual (Page 126)

Command Line Interface 126
Frame Relay Commands
ENABLE FRELAY COMPRESSION
DISABLE FRELAY COMPRESSION
Enables/disables compression when Frame Relay is used.
SET FRELAY CIR bitspersecond
Defines the Committed Information Rate (CIR) in bits per second. The CIR is the rate at which
the network transfers information under normal conditions. The service provider typically sets
pricing based on the CIR (including other criteria) with rate guarantees.
Range: 2400-204800.
SET PROFILE DLCI dlcinumber
Defines the DLCI number for the current profile.
A DLCI is the Frame Relay equivalent of a hardware address, associated with an established
Permanent Virtual Circuit (PVC).
Range: 16-1007.
SET FRELAY DLCI oldNum newNum
Modifies a Data Link Connection Identifier (DLCI). A DLCI is the Frame Relay equivalent of a
hardware address, associated with an established Permanent Virtual Circuit (PVC).
oldNum: The existing DLCI to be modified.
newNum: A new DLCI number to be set.
Range: 16-1007.
SET DLCI WINDOWSIZE dlciNum winSize
Defines the Frame Relay window size for the specified DLCI.
dlciNum: The existing static DLCI number.
Range: 16-1007.
winSize: The window size to be set for this DLCI.
Range: 1-255. Default: 2.
SET FRELAY DLCIMODE { DYNAMIC | STATIC }
Defines the DLCI mode.
DYNAMIC: Enables dynamic configuration of new DLCIs for this connection. Dynamic DLCI
(also referred to as \"DLCI discovery\") eliminates the need for static configuration of new
DLCIs. All previously configured DLCIs for this connection are removed. Dynamic DLCI is
performed automatically by the Frame Relay Bearer Service, so you do not have to configure a
separate DLCI for each Permanent Virtual Circuit in your Frame Relay network.
STATIC: Enables static configuration of new DLCIs for this connection. In this mode, each
DLCI must be defined manually.