Eicon Networks 1530 - Manual (Page 154)

Command Line Interface 154
SET X25 ACKTIMER AckTimer
Defines the Acknowledge timer, which is how long, in milliseconds, the line can remain idle
before an RR (Receiver Ready) is sent to the remote. This lets the remote know that the
connection is still active. The remote will respond with an RR.
Range: 0-9999.
Default: 20.
SET X25 IDLETIMER seconds
Defines the amount of time a dial-up connection can be inactive before the link is brought
down.
Range: 1-999 seconds. Specify 0 to disable automatic disconnection.
Default: 30 seconds.
SET X25 MAXIDLETIME seconds
Defines the maximum amount of time an X.25 connection can be idle before the connection is
dropped.
Range: 1-600 seconds. Specify 0 to disable automatic disconnection.
Default: 20 seconds.
SET X25 MAXRETRY number
Defines the maximum number of attempts this profile makes to establish a connection with this
profile. When this limit is reached, the profile is the \"failed\" state. To reset the profile
manually, dial it or reset the Eicon 1530.
Range: 0-250.
Default: 10.
SET X25 RETRYDELAY interval
Defines the amount of time to wait after a failed connection attempt, before retrying.
Range: 0-1800 seconds. Default: 5 seconds.
SET X25 MINCONTIME seconds
Defines the minimum amount of time an X.25 connection must stay connected.
Range: 0-1800 seconds.
Default: 30 seconds.
SET X25 N3 MaxRetryCount
Defines how many times an X.25 packet that is not successfully being received by the remote
will be retransmitted.
Range: 0-99.
Default: 3.