KACO Powador 30.0 - 60.0 TL3 - Manual (Page 6)

Safety
Page 6 Operating Instructions for Powador 30.0-72.0 TL3_EN
EN EN
2.1 Proper use
The inverter converts the DC voltage generated by the PV modules into AC voltage and feeds it into the grid. The
inverter is built according to the latest technological standards and safety regulations. Nevertheless, improper use
may cause lethal hazards for the operator or third parties, or may result in damage to the unit and other property.
Operate the inverter only with a permanent connection to the public power grid.
Any other or additional use of the device shall be regarded as improper. This includes:
• Mobile use,
• Use in potentially explosive atmospheres,
• Use in rooms where the humidity is higher than 95%
• Use in outdoor areas if the inverter is exposed to direct sunlight, rain or a storm,
• Use less than 100 m distant from the coast,
• Operation outside the specifi cations intended by the manufacturer,
• Islanding operation.
2.2 Protection features
For your safety, the following monitoring and protective functions are integrated into Powador inverters:
• Overvoltage conductors/varistors to protect the power semiconductors from high-energy transients on the grid
and generator side
• Temperature monitoring of the heat sink
• EMC fi lters to protect the inverter from high-frequency grid interference
• Grid-side grounded varistors to protect the inverter against burst and surge pulses
• Islanding detection according to VDE 0126-1-1
2.3 Trademark
The software of the inverter uses the MD5 Message Digest algorithm of RSA Data Security, Inc.
2.4 Additional information
NOTE
The EU Declaration of Conformity can be found in the appendix.
For information on grid coupling, grid protection and safety parameters along with more detailed
instructions see our web site at http://www.kaco-newenergy.de/.