KACO Powador 30.0 - 60.0 TL3 - Manual (Page 17)

Mounting the inverter
Operating Instructions for Powador 30.0-72.0 TL3_EN Page 17
EN
Authorised electrician
735
1328
140
766.5
45
Figure 7: Drilling separation (in mm) Figure 8: Instructions for wall mounting
6.1 Installing and securing the inverter
Drilling the holes
1. Mark (4x) drill holes on bottom.
2. For wall mounting: Mark the position of the holes on the wall (2x) and insert the wall anchors in the wall for
additional security.
3. Drill the holes. Floor: 12 mm diameter, wall: 9 mm diameter.
» Install and secure the inverter.
Securing the inverter
1. Position the inverter above the drill holes.
2. Use the four anchoring bolts to secure the inverter to the fl oor.
3. For installations at a wall: secure the inverter to the wall with two screws.
» Install the housing.
6.1.1 Fitting the housing (30.0-48.0 TL3)
Removing the EMC sheet metal
1. Unscrew the 4 M4 x 10 screws from the EMC sheet metal.
2. Remove and store the EMC sheet metal.
» Install the hood.
Installing the hood
↻ Remove the EMC sheet metal.
1.
Place the hood on the top side of the housing.
2. Secure the hood to the inverter housing from the inside using the enclosed fastening screws.
» Install the side housing covers.