KACO Powador 30.0 - 60.0 TL3 - Manual (Page 41)

Configuration and Operation
Operating Instructions for Powador 30.0-72.0 TL3_EN Page 41
EN
Coun-
try-spec.
setting
menu
level
Display/
setting
Action in this menu/meaning
DE, CH, BE,
GB, PL, IT, AT,
ES, KR, UD
4 1 2 3 2 cos-phi(P/Pn)
 Open the menu: Press the right arrow button or the
OK button.
GB, CH, IT, AT,
ES, KR
4 1 2 3 3 Lock-in voltage
 Power range set as % of rated voltage, where the
network support process is active.
4 1 2 3 3
Lock-out
voltage
DE, CH, BE,
FR, GB, IL, IT,
AT, PL, RU, ES,
KR, TH, UD
4 1 2 3 3
Number of
nodes
This option defi nes how many support points can be
defi ned in the subsequent menu. The maximum number
of confi gurable support points depends on the selected
grid type.
 Specify the number of support points for the idle
power characteristic curve.
4 1 2 3 3
1., 2. ...Support
point
 Specify the power factor for the 1st, 2nd (etc.) sup-
port point
 If a power factor is selected which is not equal to 1:
Select the type of phase shift (under-excited/
over-excited).
CH, GB, IT, PL,
AT, KR
4 1 2 3 2 Q(U) 5 Supports
 Open the menu: Press the right arrow button or the
OK button.
4 1 2 3 3 Lock-in power
 Power range set as % of rated power, in which the
network support process is active.
4 1 2 3 3 Lock-out power
4 1 2 3 3 Time constant  Set the response speed of the control.
4 1 2 3 3
Number of support
points
 Specify the number of support points for the idle
power characteristic curve.
4 1 2 3 3
1., 2. ...Support
point
 Specify the support points for voltage, power and
nature of the phase shift
CH, GB, IT, KR
4 1 2 3 2 Q(U) 2-point
 Open the menu: Press the right arrow button or the
OK button.
4 1 2 3 3 Lock-in power
 Power range set as % of rated power, in which the
network support process is active.
4 1 2 3 3 Lock-out power
4 1 2 3 3 Time constant  Set the response speed of the control.
4 1 2 3 3 1.-4. Support point
 Specify the support points for voltage, power and
nature of the phase shift
DE-NSp, CH;
BE
4 1 2 3 1 Line error
Display of grid faults.
 To show the last 5 grid fault messages, select the
“Display” key.
CH, BE, CY,
DE-NSp
4 1 2 3 1
Protection param-
eters
Display of essential protection parameters.
 To show the protection parameters, select the “Dis-
play” key.