KACO Powador 30.0 - 60.0 TL3 - Manual (Page 24)

Installing the inverter
Page 24 Operating Instructions for Powador 30.0-72.0 TL3_EN
EN EN
Authorised electrician
MPP-Tracker 1
30.0-48.0 TL3
MPP-Tracker 3 MPP-Tracker 2
U MPP
U MPP
1 2 3 4 1 2 3 4 1 2 3 4
n
1
= n
2
= n
3
= n
4
n
5
= n
6
= n
7
= n
8
n
9
= n
10
= n
11
= n
12
MPP-Tracker 1 MPP-Tracker 3 MPP-Tracker 2
U MPP
U
MPP
n
1
= n
2
= n
3
= n
4
= n
5
n
6
= n
7
= n
8
= n
9
= n
10
n
11
= n
12
= n
13
= n
14
= n
15
1 2 3 4 5 1 2 3 4 5 1 2 3 4 5
60.0 TL3
Figure 22: Recommended standard connection, XL variant (left: 39.0 TL3, right: 60.0 TL3)
7.3.2.4 Connecting the PV generator
DANGER
Risk of fatal injury due to electric shock
Severe injury or death will result if the live connections are touched. When there is solar radiation, DC
voltage will be present at the open ends of the DC cables.
› Do not touch the exposed ends of the cables.
›
Avoid short circuits.
Connecting the PV generator
1. Unscrew the cable fi ttings.
2. Remove the outer cladding of the DC cables.
3. Insert the DC cables through the cable fi ttings into the connection area.
4. Strip the insulation from the DC cables.
5. Connect the ends of the cables to the DC connections.
6. Check that all connected cables are securely fi tted.
7. Tighten the cable fi ttings.
8. The requirements of protection rating IP54 are met by closing the unused cable fi ttings with blind caps.
» The inverter is connected to the PV generator.
7.4 Connecting the interfaces
All interfaces are located on the connection circuit board in the upper area of the inverter door. Use the cable fi t-
tings provided and connect the connection cables to the circuit board.