Yaskawa 120 Series I/O Modules - Manual (Page 54)

3 Digital I/O Specifications
3.2.1 100/200-VAC 8-point Output Module
3-24
3.2 Digital Output Module Specifications
3.2.1 100/200-VAC 8-point Output Module - - - - - - - - - - - - - - - - - - - - - - - 3-24
3.2.2 100/200-VAC 16-point Output Module - - - - - - - - - - - - - - - - - - - - - - 3-28
3.2.3 12/24-VDC 8-point Output Module - - - - - - - - - - - - - - - - - - - - - - - - 3-32
3.2.4 12/24-VDC 16-point Output Module (Sinking) - - - - - - - - - - - - - - - - 3-36
3.2.5 12/24-VDC 16-point Output Module (Sourcing) - - - - - - - - - - - - - - - 3-40
3.2.6 12/24-VDC 32-point Output Module - - - - - - - - - - - - - - - - - - - - - - - 3-44
3.2.7 12/24-VDC 64-point Output Module - - - - - - - - - - - - - - - - - - - - - - - 3-49
3.2.8 Relay Contact 16-point Output Module - - - - - - - - - - - - - - - - - - - - - 3-55
3.2.1 100/200-VAC 8-point Output Module
1) Performance Specifications
This section describes the performance specifications, circuit configuration, external
connections, and external appearance of the 120-series Digital Output Modules.
Item Specifications
Name 100/200-VAC 8-point Output Module
Model Name ACOUT-8P
Model No. JAMSC-120DAO83000
Rated Voltage 100/200 VAC
Allowable Voltage Range 80 to 264 VAC
Rated Frequency 50/60 Hz
Allowable Frequency Range 47 to 63 Hz
Maximum Load Current 1.0 Arms/point
Output Voltage Drop 1.0 Vrms
Output Delay Times OFF to ON: 5 ms max.
ON to OFF: 1/2 cycle + 5 ms max.
OFF Leakage Current 3 mA max. at 240 VAC, 50 Hz
Minimum Load Current 10 mArms
Output Type Triac outputs
Number of Commons 8 (Each output circuit is independent.)
Output Power Supply
per Common Possible to connect different power supply phases to the commons.
External Connections Removable terminal block with M3 screw terminals
Output Protection Type Unprotected outputs (according to JIS B3502)
Built-in Fuse None
Surge Suppressor Varistor
Other Output Protection None
Number of Outputs 8
Output Signal Indication Indicator for each point; lit when the output is ON.
Status saved in internal logic.
Status Indication ACTIVE: Lights during input processing.
Insulation Method Phototriac
Dielectric Strength 1,500 VAC for 1 min or 1,800 VAC for 1 s between output terminals and
internal circuits and between all output circuits.