2) setting the module type – Yaskawa 120 Series I/O Modules User Manual

Page 191

Text mode
Original mode

4 Analog I/O Specifications

4.4.3 I/O Allocations

4-44

• Software Filter (No filter/Ave 3 times/Ave 5 times)

Note: This item is to be set only for Analog Input Modules.

• Timeout Output (Open/Hold/Set by user)

Note: This item is to be set only for Analog Output Modules.

2) Setting the Module Type

Set the Module Type in the following procedure.

(1) Start the MEMOSOFT and select Online from the Mode Menu.

Fig. 4.5 Mode Selection: Online

I/O allocations cannot be performed while the CPU Module is in RUN status. If
necessary, stop the CPU Module. Refer to 6.1 PLC Operations in the
MEMOSOFT User’s Manual (Manual number SIEZ-C825-60.10) for the proce-
dure to stop the CPU Module.

(2) Press the F2 (Config) Key to access the PLC System Configuration Screen.

Fig. 4.6 PLC System Configuration Screen

fx2