Yaskawa 120 Series I/O Modules - Manual (Page 225)

5.4 Operations Using MEMOSOFT
5-27
5
7) Cycle Setting
Make sure that the Parameter Setting Screen (I/O Map Module Editor) is being dis-
played.
(1) Move the cursor to Cycle and press the Enter Key to access the cycle setting.
Fig. 5.21 Parameter Setting Screen: Cycle
(2) A screen appears so that the cycle setting can be selected.
Move the cursor to the desired cycle or “USER SET” and press the Enter Key
to select the desired cycle.
The MEMOSOFT is set by default to 32/64 ms.
Fig. 5.22 Cycle Selection