Yaskawa 120 Series I/O Modules - Manual (Page 243)

6 Installation and Wiring
6.2.2 Wiring AC I/O Modules
6-16
Example 2: Load Driving Power Supply for 100/200 VAC 16-point Output Module
Fig. 6.2 Load Driving Power Supply
2) AC Power Supply Cables
Do not allow foreign matter such as cable chips in the Modules or Mounting Bases.
Foreign matter in the Modules or Mounting Bases may cause fire, failures and/
or malfunctions.
a) Five types of AC I/O Modules are available. See Table 6.4.
To connect these I/O Modules to an AC power supply, use recommended size of
cable listed in Table 6.4. The cables differ in their allowable current capacity
depending on the conditions of use, such as the ambient operating temperature, so
check the conditions of use and select a cable of appropriate size.
b) M3 Phillips screws are used in the external connection terminals. Use crimp termi-
nals that are specially designed for M3 Phillips screws for the Module end of the
power supply cable.
Load driving power
supply(single-phase,
100/200 VAC, 50/60 Hz)
Fuse Load
Fuse Load
Output 1
Output 2
Output 3
Output 4
Output 5
Output 6
Output 7
Output 8
Common 1-1
Common 1-2
Output 9
Output 10
Output 11
Output 12
Output 13
Output 14
Output 15
Output 16
Common 2-1
Common 2-2
JAMSC-120DAO84300
CAUTION
Table 6.4 Power Supply Cable Size
Name Model No. Power Supply Cable Size
100-VAC 16-point Input Module JAMSC-120DAI54300
0.5 mm 2 (AWG20) to 1.3 mm 2
(AWG16) 200-VAC 16-point Input Module JAMSC-120DAI74300
100/200-VAC 8-point Output Module JAMSC-120DAO83000
100/200-VAC 16-point Output Module JAMSC-120DAO84300
1.3 mm
2
(AWG16) or larger
Relay Contact 16-point Output Module JAMSC-120DRA84300 AC loads:
1.3 mm
2 (AWG16) or larger