HEIDENHAIN TNC 320 (77185x-01) - Manual (Page 68)

Introduction
2.3 Modes of Operation
2
68
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
Test Run
In the Test Run mode of operation, the TNC checks programs and
program sections for errors, such as geometrical incompatibilities,
missing or incorrect data within the program or violations of the
working space. This simulation is supported graphically in different
display modes.
Soft keys for selecting the screen layout: see "Program Run, Full
Sequence and Program Run, Single Block", page 68.
Program Run, Full Sequence and Program Run, Single
Block
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or to a manual
or programmed stop. You can resume program run after an
interruption.
In the Program Run, Single Block mode of operation you execute
each block separately by pressing the machine START button.
Soft keys for selecting the screen layout
Window Soft key
Program
Left: program, right: program structure
Left: program, right: status
Left: program, right: graphics
Graphics