HEIDENHAIN TNC 320 (77185x-01) - Manual (Page 429)

Datum setting without a 3-D touch probe 13.4
13
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
429
Editing the preset table
Editing function in table mode Soft key
Select beginning of table
Select end of table
Select previous page in table
Select next page in table
Select the functions for preset entry
Display the "Basic Transformation/Axis Offset"
selection
Activate the datum of the selected line of the
preset table
Add the entered number of lines to the end of
the table (2nd soft-key row)
Copy the highlighted field (2nd soft-key row)
Insert the copied field (2nd soft-key row)
Reset the selected line: The TNC enters - in all
columns (2nd soft-key row)
Insert a single line at the end of the table (2nd
soft-key row)
Delete a single line at the end of the table
(2nd soft-key row)