HEIDENHAIN TNC 320 (77185x-01) - Manual (Page 175)

Tool data 5.2
5
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
175
Column Meaning
WTIME Tool-usage time in seconds (total usage
time between tool changes)
RAD Tool radius R + Oversize of tool radius
DR from the tool table. (in mm)
BLOCK Block number in which the TOOL CALL
block was programmed
PATH TOKEN = TOOL: Path name of the active
main program or subprogram
TOKEN = STOTAL: Path name of the
subprogram
T Tool number with tool index
OVRMAX Maximum feed rate override that occurred
during machining. During Test Run the
TNC enters the value 100 (%)
OVRMIN Minimum feed rate override that occurred
during machining. During Test Run the
TNC enters the value –1
NAMEPROG 0: The tool number is programmed
1: The tool name is programmed
There are two ways to run a tool usage test for a pallet file:
The highlight in the pallet file is on a pallet entry: The TNC runs
the tool usage test for the entire pallet
The highlight in the pallet file is on a pallet entry: The TNC runs
the tool usage test for the entire pallet