HEIDENHAIN TNC 320 (77185x-01) - Manual (Page 35)

TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
35
13 Manual operation and setup.......................................................................................................407
13.1 Switch-on, switch-off..........................................................................................................................408
Switch-on...............................................................................................................................................408
Switch-off...............................................................................................................................................410
13.2 Moving the machine axes..................................................................................................................411
Note.......................................................................................................................................................411
Moving the axis with the machine axis direction buttons.................................................................... 411
Incremental jog positioning...................................................................................................................411
Traverse with electronic handwheels....................................................................................................412
13.3 Spindle speed S, feed rate F and miscellaneous function M......................................................... 422
Application............................................................................................................................................. 422
Entering values......................................................................................................................................422
Adjusting spindle speed and feed rate................................................................................................. 423
Activating feed-rate limitation............................................................................................................... 423
13.4 Datum setting without a 3-D touch probe.......................................................................................424
Note.......................................................................................................................................................424
Preparation.............................................................................................................................................424
Workpiece presetting with axis keys.................................................................................................... 424
Datum management with the preset table.......................................................................................... 425
13.5 Using 3-D touch probes..................................................................................................................... 431
Overview............................................................................................................................................... 431
Functions in touch probe cycles........................................................................................................... 432
Selecting touch probe cycles................................................................................................................434
Recording measured values from the touch-probe cycles................................................................... 435
Writing measured values from the touch probe cycles in a datum table............................................. 436
Writing measured values from the touch probe cycles in the preset table.......................................... 437
13.6 Calibrating a 3-D touch trigger probe...............................................................................................438
Introduction........................................................................................................................................... 438
Calibrating the effective length............................................................................................................. 439
Calibrating the effective radius and compensating center misalignment............................................. 440
Displaying calibration values................................................................................................................. 442