HEIDENHAIN TNC 320 (77185x-01) - Manual (Page 57)

Setting up tools 1.5
1
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
57
1.5 Setting up tools
Selecting the correct operating mode
Tools are set up in the Manual Operation mode:
Press the operating-mode key: The TNC switches
to the
Manual mode of operation
Further information on this topic
Operating modes of the TNC: see "Modes of Operation",
page 67
Preparing and measuring tools
Clamp the required tools in their chucks
When measuring with an external tool presetter: Measure the
tools, note down the length and radius, or transfer them directly
to the machine through a transfer program
When measuring on the machine: store the tools in the tool
changer page 59