HEIDENHAIN TNC 320 (77185x-01) - Manual (Page 34)

Contents
34
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
12 Programming: Multiple Axis Machining.................................................................................... 379
12.1 Functions for multiple axis machining............................................................................................. 380
12.2 The PLANE Function: Tilting the Working Plane (Software Option 1)...........................................381
Introduction........................................................................................................................................... 381
Defining the PLANE function................................................................................................................383
Position display......................................................................................................................................383
Resetting the PLANE function..............................................................................................................384
Defining the working plane with the spatial angle: PLANE SPATIAL....................................................385
Defining the working plane with the projection angle: PLANE PROJECTED....................................... 387
Defining the working plane with the Euler angle: PLANE EULER........................................................388
Defining the working plane with two vectors: PLANE VECTOR.......................................................... 390
Defining the working plane via three points: PLANE POINTS..............................................................392
Defining the working plane via a single incremental spatial angle: PLANE SPATIAL............................394
Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function)......................................395
Specifying the positioning behavior of the PLANE function.................................................................397
12.3 Miscellaneous functions for rotary axes.......................................................................................... 402
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1).............................................. 402
Shortest-path traverse of rotary axes: M126........................................................................................403
Reducing display of a rotary axis to a value less than 360°: M94........................................................404
Selecting tilting axes: M138................................................................................................................. 405