HEIDENHAIN TNC 320 (77185x-01) - Manual (Page 62)

First Steps with the TNC 320
1.7 Running the first program
1
62
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
1.7 Running the first program
Selecting the correct operating mode
You can run programs either in the Single Block or the Full
Sequence mode:
Press the operating-mode key: The TNC goes into
the
Program Run, Single Block mode and the
TNC executes the program block by block. You
have to confirm each block with the NC start key
Press the operating-mode key: The switches
to the
Program Run, Full Sequence operating
mode: The TNC switches to that mode and
runs the program after NC start up to a program
interruption or to the end of the program
Further information on this topic
Operating modes of the TNC: see "Modes of Operation",
page 67
Running programs: see "Program run", page 483
Choosing the program you want to run
Press the PGM MGT key: The TNC opens the file
management
Press the LAST FILES soft key: The TNC opens a
pop-up window with the most recently selected
files
If desired, use the arrow keys to select the
program that you want to run. Load with the ENT
key
Further information on this topic
File management: see "Working with the file manager",
page 102
Start the program
Press the NC start key: The TNC runs the active
program
Further information on this topic
Running programs: see "Program run", page 483