HEIDENHAIN TNC 320 (77185x-01) - Manual (Page 183)

Tool movements 6.1
6
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
183
Subprograms and program section repeats
If a machining sequence occurs several times in a program, you
can save time and reduce the chance of programming errors by
entering the sequence once and then defining it as a subprogram
or program section repeat. If you wish to execute a specific
program section only under certain conditions, you also define this
machining sequence as a subprogram. In addition, you can have a
part program call a separate program for execution.
Programming with subprograms and program section repeats is
described in Chapter 7.
Programming with Q parameters
Instead of programming numerical values in a part program, you
enter markers called Q parameters. You assign the values to the Q
parameters separately with the Q parameter functions. You can use
the Q parameters for programming mathematical functions that
control program execution or describe a contour.
In addition, parametric programming enables you to measure with
the 3-D touch probe during program run.
Programming with Q parameters is described in Chapter 8.