HEIDENHAIN TNC 320 (77185x-01) - Manual (Page 160)

Programming: Tools
5.2 Tool data
5
160
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
Abbr. Inputs Dialog
TYPE Tool type: Press the ENT key to edit the field; the GOTO
key opens a window in which you can select the tool
type. You can assign tool types to specify the display
filter settings such that only the selected type is visible in
the table
Tool type?
DOC Comment on tool (up to 32 characters) Tool comment?
PLC Information on this tool that is to be sent to the PLC PLC status?
PTYP Tool type for evaluation in the pocket table Tool type for pocket table?
NMAX Limit the spindle speed for this tool. The programmed
value is monitored (error message) as well as an increase
in the shaft speed via the potentiometer. Function
inactive: Enter
–.
Input range : 0 to +999999, if function not active: enter –
Maximum speed [rpm]?
LIFTOFF Definition of whether the TNC should retract the tool in
the direction of the positive tool axis at an NC stop in
order to avoid leaving dwell marks on the contour. If
Y
is defined, the TNC retracts the tool from the contour,
provided that this function was activated in the NC
program with M148 . see "Automatically retract tool from
the contour at an NC stop: M148", page 355
Retract tool Y/N ?
TP_NO Reference to the number of the touch probe in the touch-
probe table
Number of the touch probe
T_ANGLE Point angle of the tool. Is used by the Centering cycle
(Cycle 240) in order to calculate the centering depth from
the diameter entry
Point angle?
LAST_USE Date and time that the tool was last inserted via TOOL
CALL
Input range : Max. 16 characters, format specified
internally: Date = yyyy.mm.dd, time = hh.mm
LAST_USE