HEIDENHAIN MSE 1300 - Manual (Page 30)

30
Connecting a cable with an M8 connector MSE 1401 (ID 747507-02)
Covers are provided for I/O connections. Leave the cover on unused connections.
To connect a cable with an M8 connector:
X X Verify that power is off or disconnected
X X Remove the connector cover using a flat-edge screw driver and turning
counterclockwise.
X X Align the cable connector with the module connector
X X Insert the cable connector into the connector on the front of the module
X X Hand tighten the M8 cable connector onto the module
Connecting and disconnecting a compressed air tube
The MSE 1501 provides 4 mm tube connections for compressed air input and output.
To connect a compressed air tube:
X X Verify that power is off or disconnected
X X Insert the 4 mm tube into the connector on the front of the module
To disconnect a compressed air tube:
X X Verify that power is off or disconnected
X X Push in on the blue connector ring and remove the 4 mm tube
7 8 9
M8 connectors
10 12
Compressed air connector