HEIDENHAIN MSE 1300 User Manual
Page 28
28
Connecting a 9-pin D-sub connector
This product provides a 9-pin D-sub connector for input of analog signals. The connecting
cable must not exceed 30 meters in length.
To connect a 9-pin D-sub connector:
X
X
Verify power is removed from all power supply modules in the module chain
X
X
Connect the cable connector to the 9-pin D-sub connection 4 on the module and
tighten the cable connector screws until they are snug
Connecting the I/O terminal block connector
The MSE 1401 (ID 747507-01) provides a terminal block I/O connection for switching
inputs and relay outputs. The switching inputs are active when a High signal (contact or
pulse) is present. They are isolated and can be supplied externally or internally. Refer to
“Relay outputs” and “Switching inputs” on page 204 for further information.
To connect the terminal block:
X
X
Verify that power is off or disconnected
X
X
Remove the male terminal connector from the module connection
X
X
Insert the required + and - wires for switching inputs or the required output wire for
relay outputs into their respective terminals on the male terminal connector
X
X
Using a small flat-edge screwdriver, tighten the screws located on the top of the cable
connector
X
X
Insert the male terminal connector into the connection on the module
4
9-pin D-sub connector
6
I/O terminal block connector