Polaris 2016 INDIAN Chief Classic - Manual (Page 95)

93
Maintenance
Engine Oil/Filter Change
Change the engine oil at the intervals specified in the
periodic maintenance table beginning on page 91. Change
the oil more frequently if the motorcycle is subjected to
severe use, especially operation in cold weather. See page
90.
NOTICE: Failure to perform frequent oil changes during cold
weather operation can result in condensation forming.
Freezing condensation can result in plugged oil lines and
serious engine damage.
The total amount of oil required for the oil and filter change
is approximately 5.5 qts. (5.2 l). Follow all instructions
carefully. Do not overfill.
NOTICE: After an oil change, the low oil pressure indicator may
illuminate when the engine is started. If this occurs, do not
increase RPM above idle speed until the indicator turns
off. Operating above idle speed could result in damage to
the engine.
1. Change the oil and filter when the engine is warm. If the
engine is cold, start the engine and allow it to run at idle
for at least 5 minutes.
2. Park the motorcycle with the sidestand down on a firm,
level surface. If using a service lift, the motorcycle
should be centered.
3. Clean the area around
the two drain plugs.
Place a drain pan under
both drain plugs.
CAUTION! Hot oil can cause
burns to skin. Do not allow hot oil
to contact skin.
4. Remove the drain plugs.
Allow the oil to drain
completely.
5. Install new sealing
washers on the drain
plugs. The sealing
surfaces on drain plugs
and engine should be
clean and free of burrs,
nicks or scratches.
6. Reinstall the drain plugs. Torque to 15 ft. lbs. (20 Nm).
CAUTION! Hot oil can cause burns to skin. Do not allow hot oil to
contact skin. Wear leather gloves when handling hot components.
7. Place shop towels beneath the oil filter. Using an oil filter
wrench, turn the filter counter-clockwise to remove it.
Scavenge Area
Drain Plug
Storage Area
Drain Plug