Polaris 2016 INDIAN Chief Classic - Manual (Page 58)

56
Instruments, Features and Controls
Trunk (if equipped)
Do not exceed the cargo capacity of a trunk, a cargo rack or
a trunk/cargo rack combination. The capacity for the trunk
alone, as well as for any trunk/cargo rack combination, is 30
lbs. (10 kg). The capacity for a rack alone is 5 lbs. (2.2 kg). If
you load a rack with 5 lbs. (2.2 kg) of cargo, do not add more
than 25 lbs. (11.3 kg) to the trunk.
Trunk Removal/Installation
1. Working from below
the trunk, reach up
onto the shelf to access
the harness plug. Slide
the plug upward and
forward to remove it
from the shelf.
2. Depress the release
tab to disconnect the
plug.
3. Place a shop towel on
the fender to prevent
scratches, then remove
the harness from the
plastic harness
support and place the
harness on the towel.
4. Open the saddlebag lids.
5. Make sure the anti-theft
latches are in the up
(released) position.
Tip: Locking bolts (if installed)
must be removed to access
the latches. This would also
require removing
saddlebags.
6. From the rear of the motorcycle, grasp the trunk bumper
firmly with both hands. Pull the trunk assembly upward
to disengage the trunk support legs from the saddlebag
support bracket bushings. Pull upward and rearward to
remove the trunk from the bike.
7. Place the trunk in a safe location to prevent damage.
8. Loop the harness and place
the wires into the fabric
pocket under the rear seat
flap. Place the connector in
the connector storage area
under the rear seat flap.
Lower the flap.
Step 1
Shelf
Plug
Step 3
Step 5
Harness Storage