Polaris 2016 INDIAN Chief Classic - Manual (Page 29)

27
Instruments, Features and Controls
Switches
Power Switch
The power switch is located on the center console. Press and
release the power switch to enable or disable all electrical
power to the vehicle. The power switch does not have to be
on to start the engine. See page 28.
To disable all electrical power if the motorcycle is moving
and the engine is running, press and hold the power switch
for more than three (3) seconds.
Tip: To save battery power, the vehicle will power off after five
minutes of inactivity.
Hazard Switch
The power switch must be ON to activate the flashers, but
once activated, the flashers will continue to flash when the
power switch is turned off. When the flashers are active, all
four turn signals flash.
• Press the switch to activate the flashers.
• Press the switch again to cancel the flashers.
Engine Stop/Run Switch
Use the engine stop/run switch
to turn the engine off quickly.
• Press the top of the switch
(STOP) to interrupt the
circuits and stop the engine.
The engine should not start or
run when the switch is in the
STOP position.
• Press the bottom of the switch
(RUN) to complete the circuits
and allow the engine to start
and run.
Tip: The headlights and any
accessories plugged into
power ports will remain on
until the power switch is turned
off.
Run
Stop
Right Control