Polaris 2016 INDIAN Chief Classic - Manual (Page 87)

85
Operation
Using Cruise Control
The cruise control switches are located on the right
handlebar. Read this section and understand how to safely
operate this feature before using the cruise control.
WARNING! Improper operation of cruise control could cause loss
of control and result in serious injury or death. Follow all cruise
operation procedures carefully. Never use cruise control when roads
are wet or slippery. Do not use cruise control when riding in heavy or
congested traffic.
Cruise Control Tips
• Cruise control can be set in gears 4-6.
• Vehicle speed must be above 20 MPH (32 km/h).
• Set speed will vary slightly in hilly terrain.
• Cruise control will not resume a pre-set speed if the resulting
acceleration or deceleration rate is too high or too low. For
example, resuming a set speed from 40 MPH (64 km/h) while in
6th gear may cause cruise to disengage.
• Cruise control will not engage if brake lights are not operating
properly.
• The clutch or either brake must have been activated at least once
since the engine was started for the cruise control to function.
Cruise On/Off
Switch
Resume/Accelerate
Switch
Set/Decelerate
Switch