Grass Valley PRS 250 RAID Storage System - Manual (Page 72)

Chapter 3 Servicing the System
3-26 RAID Instructions
4. Remove the SP from the chassis as shown below.
Removing an SP
5. Install a SP filler board. See “Removing or Installing an SP Filler Board” on
page 28.
6. Immediately close and lock the fan module.
IMPORTANT Before shipping a failed SP, remove its memory modules.
(See Removing SP Memory Modules.)
7. Remove and store the ESD wrist band.
Ejectors
SP B* SP A
A.Pull both ejectors until they
unlock and SP starts coming
out of chassis.
B.Rest edge of SP on palm of
hand, and with other hand pull
it out of chassis, making sure
not to any touch any electronic
components or circuits.
C.Place SP component-side up
on static-free work surface.
* The SP B location is occupied by a SP Filler Board.