Grass Valley PRS 250 RAID Storage System - Manual (Page 35)

Configurations and Cabling
RAID Instructions 2-17
Four Channel Profile/2 RAIDs
This configuration, see the following illustration, consists of a 4-channel Profile (one
MDR and one Slave Disk Recorder - SDR) and two symmetrical RAID Storage
chassis (each RAID chain with the same number of disk modules).
1. Connect a SCSI-2 cable from the Profile MDR rear panel connector to the RAID
chassis SCSI A IN connector
2. Connect a second SCSI-2 cable from the SDR rear panel connector to a second
RAID SCSI A IN connector.
3. Connect a SCSI terminator plug to each RAID chassis SCSI A OUT connector.
0226-6
J11 J10
SCSI-2 Terminator
SCSI-2 Cable
Note:
Each RAID chassis must have
the same number of drives.
4-Channel Profile Disk Recorder
RAID Chassis