Grass Valley PRS 250 RAID Storage System - Manual (Page 27)

Removal of Profile Internal Disk Drives
RAID Instructions 2-9
Installing the internal disk recorder terminator
.
10. Reinstall the Profile covers.
Removing PDR200 Internal Disk Drives
To remove the internal disk drives from the PDR200 perform the following
procedure:
1. Turn all power to the Profile system off.
NOTE: You should NOT discard any hardware or cables.
2. Refer to your Profile Service Manual to remove the top covers from the Profile
chassis.
3. Refer to your Profile Service Manual to remove the hard disks from the system. At
the same time, remove the SCSI cable(s) connected between the disk recorder
board(s) and the SCSI Distribution board.
4. Reinstall the Profile chassis covers.
9674-20
1
2