Grass Valley UniConfi NVISION Series v.2.1 - Manual (Page 72)

60
Switch Point Settings
Switch Point Settings
NV8500 Family Standard Routers
 Use MRC, not UniConfig, to configure NV8500 hybrid routers — those having EM0833
control cards. You must use UniConfig to configure NV8500 routers that have EM0666
control cards.
1 Select a control card (for an NV8144, NV8140, NV8280, NV8576, or NV8576-Plus frame).
2 From the ‘Window’ menu, select ‘Switch Point Setup’. The ‘Switch Point Setup’ window
appears. Specify an output range at the bottom of the page and click Read Outputs:
Fig. 7-6: Switch Point Setup Window (NV8280)
This table describes each column in the output list:
Column Description
Output The number assigned to the signal for routing purposes. The number usually
refers to the physical port through which the signal is distributed.
Reclock/bypass Indicates whether the output bypasses re-clocking.
HD/SD Indicates whether the output is a standard definition (SD) or high definition (HD)
video signal.
Ref1/Ref2 Indicates whether the output uses video reference 1 or reference 2 (in dual refer-
ence mode only).