Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 98)

98 K2 Summit Production Client Service Manual 12 October 2009
Chapter 5 Removing and replacing FRUs
Internal Parts Removal
The sections that follow show how to remove internal parts from the K2 Summit
Client.
• “Top cover removal” on page 98
• “Disk backplane unit removal” on page 99
• “Front interconnect board removal” on page 100
• “Disk controller board removal” on page 101
• “Midplane board removal” on page 102
CAUTION: To avoid possible damage to circuit boards and other
sensitive parts, turn off the K2 Summit Client and disconnect both
power cords before opening the top cover or removing any internal
parts.
Top cover removal
To access the internal hardware, first remove the top cover as shown:
!
Remove 10 top screws 2
Remove 2 side screws 3
Remove 3 rear screws 1
Slide back
and then lift
to remove top 4