Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 55)

12 October 2009 K2 Summit Production Client Service Manual 55
Identify adapters
3. Verify that there are four adapters listed, named “Intel® PRO/1000 PT Dual Port
Server Adapter…”, with an enumerator at the end of the name.
The 1394 adapter is for the IEEE 1394a port on the rear panel. This port is for
debugging purposes only. It is not supported for customer use. Do not attempt to
configure or otherwise use this port.
4. For each adapter shown, identify its location, as follows:
a. Under Network adapters, right-click one of the adapters and select Properties .
The Properties dialog box opens.
b. On the General tab and take note of Location displayed within the parentheses.
You must make a written record of the “Intel® PRO/1000 PT Dual Port Server
Adapter…” enumerator that the Windows operating system has assigned to this
location (PCI bus X, device 0, function X). Use the table below and fill in the
blanks:
On this K2 Summit Client, Windows has
assigned this adapter name… To this location:
Intel® PRO/1000 PT Dual Port Server Adapter PCI bus ____, device 0, function ____
Intel® PRO/1000 PT Dual Port Server Adapter #2 PCI bus ____, device 0, function ____
Intel® PRO/1000 PT Dual Port Server Adapter #3 PCI bus ____, device 0, function ____