Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 70)

70 K2 Summit Production Client Service Manual 12 October 2009
Chapter 3 Service Procedures
The K2 Summit Client restarts automatically.
11. Remove the USB Recovery Flash Drive while the K2 Summit Client is shutting
down.
12. Store the Recovery CompactFlash boot media in a place where it can be retrieved
quickly and easily identified with the K2 Summit Client it restores.
13. If a system fault occurs and you need to restore the K2 Summit Client, you can do
so using the the Recovery CompactFlash boot media as follows:
a. Shutdown the K2 Summit Client.
b. Exchange the current CompactFlash boot media with the K2 Summit Client’s
Recovery CompactFlash boot media.
NOTE: On an individual K2 Summit Client use only the Recovery CompactFlash
boot media prepared for that specific K2 Summit Client. Do not attempt to use the
Recovery CompactFlash boot media from a different K2 Summit Client.
c. Start up the K2 Summit Client.
The K2 Summit Client boots from the Recovery CompactFlash boot media with
the system intact as it existed when you created the Recovery CompactFlash boot
media.
Installing the Fibre Channel card driver
If your K2 Summit Client has the optional Fibre Channel card, the driver for the Fibre
Channel card is not on the recovery image provided by Grass Valley for that K2
Summit Client. Therefore, after restoring the image, you must install the Fibre
Channel card driver as instructed in this procedure.
1. Make sure that you have access to the Fibre Channel card driver file. On the local
K2 Summit Client, in C:\Windows look for LSI_SCSIPORT_1.21.25.00, then do
one of the following:
• If the file is present, continue with the next step in this procedure.
• If the file is not present, procure the file from f tp://ftp.grassvalley.com/pub/K2/
Microcode_and _Drivers/LSI_SCSIPORT. The filename is
LSI_SCSIPORT_1.21.25.00.zip. Then continue with this procedure
2. After restoring the image and restarting the K2 Summit Client, a Found New
Hardware wizard opens for the Fibre Channel controller. Install the driver on the
first FC port as follows:
a. Select Install from a list or specific location . Click Next .
b. Select Don’t search. I will choose the driver to install . Click Next .
c. Select SCSI and Raid Controllers and Have Disk .
d. Browse to C:\Windows and find LSI_SCSIPORT_1.21.25.00. Click Open and
OK .
e. Start the driver install by selecting Next .
f. On the Hardware Installation page, click Continue Anyway .