Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 64)

64 K2 Summit Production Client Service Manual 12 October 2009
Chapter 3 Service Procedures
Checking pre-installed software
Software is pre-installed on K2 products when you receive them from the factory.
This load of pre-installed software is referred to as the “golden drive”. The following
list is an example of the software pre-installed. Check K2 Release Notes for the most
up-to-date list with version information.
If you suspect that pre-installed software is not correct, use the recovery process to
re-load the software. Do not attempt to un-install, install, or repair pre-installed
software without guidance from your Grass Valley Support representative.
K2 Summit Client pre-installed software
• Intel Pro Software
• QuickTime
• Microsoft iSCSI Initiator
• MS XML
• .NET Framework
• MegaRAID — Do not use this utility on a K2 Summit Client. This utility is for use
Grass Valley FTP Daemon Manual Intentionally not started by Status
Server service on shared storage
models. Transfers go to K2 Media
Server, not K2 Summit Client.
Grass Valley Host File Service Started Automatic —
Grass Valley K2 Config Started Automatic Needed on shared storage K2
Summit Client
Grass Valley MegaRaid Server Started Manual —
Metadataservice Started Manual —
Grass Valley RTS Config Service Started Automatic —
Grass Valley Storage Utility Host Started Automatic —
Grass Valley System Status Server Started Automatic At startup the Status Server service
makes sure the following services
are started:
-AMP TCP Service
-AppService
Grass Valley Transfer Queue Service Started Automatic Not used on an shared storage K2
Summit Client. Transfers go to K2
Media Server, not K2 Summit
Client.
Microsoft iSCSI Initiator Service Started Automatic Needed on shared storage K2
Summit Client
a.
With SNFS version 3.5, this is the only service. Previous versions had StorNext File System service and
StorNext File System RPC Port Mapper service.
Service Status Startup
Type Comments