Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 42)

42 K2 Summit Production Client Service Manual 12 October 2009
Chapter 2 System Messages
About system messages
The following messages are displayed to indicate K2 Summit Client status:
• Normal BIOS messages — These messages can be observed on a locally connected
VGA monitor during normal startup processes
• BIOS POST error messages — If there is a problem these messages are displayed
on a locally connected VGA monitor. During the Power On Self Test (POST), the
BIOS checks for problems and displays these messages.
• K2 Summit Client startup messages — As AppCenter opens the K2 Summit Client
determines if system health is adequate by checking critical subsystems. A dialog
box is displayed that indicates progress and displays messages. Refer to
“Critical
system startup messages” on page 43 .
• Status bar and StatusPane messages — During normal operation AppCenter
displays system status messages on the status bar. From the status bar you can open
the StatusPane to see both current and previous messages. You can observe these
messages in AppCenter on a locally connected VGA monitor or on a network
connected control point PC. Refer to
“Viewing AppCenter system status
messages” on page 43 .
• Storage Utility messages — While you are using Storage Utility, pop-up message
boxes inform you of the current status of the storage system.
• NetCentral messages — If you are monitoring the K2 Summit Client with
NetCentral, the NetCentral interface displays a variety of messages and other status
indicators. Refer to the NetCentral Help menu for a complete list of all the
messages that a monitored device can send.