Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 84)

84 K2 Summit Production Client Service Manual 12 October 2009
Chapter 4 Troubleshooting problems
Timecode problems
For the corrective actions in this section, refer to the K2 AppCenter User Manual for
detailed instructions
Problem Possible Causes Corrective Actions
Recorded timecode reads
xx.xx.xx.xx. During recording, the channel
had no timecode source. Check that you have the right
record channel timecode source
selected, verify that timecode is
present in the source, and record
the clip again. You can also
stripe the timecode on an
existing clip.
A clip shows no mark-in/
mark-out timecode, the current
timecode display shows
XX:XX:XX:XX, or the last
valid timecode is displayed. The selected timecode source
was missing or intermittent
during recording.