Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 60)

60 K2 Summit Production Client Service Manual 12 October 2009
Chapter 3 Service Procedures
b. Select the Settings tab.
c. Click Modify Team . A dialog box opens.
11. On the Adapters tab, do the following:
a. Select the top entry, which is the adapter name that maps to Control Connection
#1 (PCI bus 4, device 0, function 1) and click Set Primary .
b. Select the adapter name that maps to Control Connection #2 (PCI bus 3, device
0, function 1) and click Set Secondary .
12. Click OK and OK and to close dialog boxes.
13. Restart the K2 Summit Client.
14. If continuing with network configuration, proceed with the next procedure “Name
team and loopback” . If network configuration is complete, enable the write filter.
Name team and loopback
1. If you have not already done so, disable the write filter.
2. On the Windows desktop right-click My Network Places and select Properties . The
Network Connections window opens.
3. For the Control Team and the loopback, select adapter names in the “Device
Name” column and rename them as follows:
a. Select the adapter name.
b. Select File | Rename to enter rename mode.
c. Type the name, as specified in the following table: