Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 94)

94 K2 Summit Production Client Service Manual 12 October 2009
Chapter 5 Removing and replacing FRUs
Power supply module removal
Access the power supply module from the rear panel. Remove as illustrated.
Codec module removal
Access the codec module from the rear panel. Remove as illustrated.
After installing the replacement codec module, install the current version of K2
software. An over-install is all that is required. You do not need to first un-install the
software. This ensures that the board is flashed with the proper version to be
compatible with K2 software.
Slide out 3
Disconnect
power cord 1
Disengage lever 2
Slide out 2
Loosen thumbscrews 1