Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 92)

92 K2 Summit Production Client Service Manual 12 October 2009
Chapter 5 Removing and replacing FRUs
External Parts Removal
This section provides the following procedures:
• “Front bezel assembly removal” on page 92
• “CompactFlash boot media removal” on page 93
• “Disk module removal” on page 93
• “Power supply module removal” on page 94
• “Codec module removal” on page 94
• “Codec option card removal” on page 95
• “Carrier module removal” on page 96
• “Fibre Channel board (optional) removal” on page 97
All the parts in this category can be removed and replaced without opening the K2
Summit Client cabinet.
Front bezel assembly removal
You can remove the bezel assembly while the K2 Summit Client is operating. If you
do so, make sure you replace it within three minutes to ensure that the correct
operating temperature is maintained.
Slide out 2
Loosen thumbscrews 1