Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 101)

12 October 2009 K2 Summit Production Client Service Manual 101
Disk controller board removal
Disk controller board removal
To remove the disk controller board, first remove the top cover, front bezel assembly,
disk modules, and disk backplane unit, then proceed as illustrated.
When installing the disk controller board, orient as illustrated.
1 Remove 4
screws
2 Disconnect from
midplane
board
Align screw
hole between
disk pillars 1 Lower into postion.
Light pipes at rear of
disk pillar are flexible
to allow passage.
2