Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 57)

12 October 2009 K2 Summit Production Client Service Manual 57
Set Rx/Tx Descriptors Value
The required mapping of names to locations is specified in the following table:
5. Proceed as follows:
• If all the names on this K2 Summit Client are configured correctly to locations,
skip ahead to the last step of this procedure.
• If names on this K2 Summit Client are not configured correctly to locations, for
each adapter name incorrectly configured, complete the remaining steps of this
procedure.
6. Select the name in the Name column.
7. Select File | Rename to enter rename mode.
8. Type the name required for the location.
9. If continuing with network configuration, proceed with the next procedure “Set Rx/
Tx Descriptors Value” . If network configuration is complete, enable the write
filter.
Set Rx/Tx Descriptors Value
1. If you have not already done so, disable the write filter.
2. In Device Manager, highlight and right-click the Intel® PRO/1000 PT Dual Port
Server Adapter .
3. Select Properties . The Properties dialog box opens.
4. Click Advanced tab.
5. In the Settings list, select Performance Options , then click the Properties button.
The Performance Options dialog box opens.
6. In the Property list, select Receive Descriptors .
7. In the Values field, if not already set correctly, use the up/down arrows to set the
value to 1024 . If 1024 is not available, select a different entry in the settings list,
then select back to Receive Descriptors. This resets the values available in the
Values field.
8. In the Settings list, select Transmit Descriptors .
9. In the Values field, set the value to 1024 .
10. Click OK to close dialog boxes and save settings.
11. Repeat this procedure on the remaining Ethernet adapters.
12. If continuing with network configuration, proceed with the next procedure “Create
The adapter name (as displayed in the Device Name
column) that is assigned to this location… Must be named as follows:
PCI bus 4, device 0, function 1 Control Connection #1
PCI bus 4, device 0, function 0 Media Connection #1
PCI bus 3, device 0, function 0 Media Connection # 2
PCI bus 3, device 0, function 1 Control Connection #2