Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 38)

38 K2 Summit Production Client Service Manual 12 October 2009
Chapter 1 Product Description
The meanings of the LED states are described in the following table:
If a LAN connector is faulty, you must replace the carrier module.
Power supply indicators
Each power supply has LEDs that indicates status.
Interpret the power supply LEDs as follows:
Another indicator of power supply operation is the audible fan noise. If a power cable
is connected to either power supply, the fan should stay on continuously on both
power supplies. This is the case even if the K2 Summit Client is shutdown or
restarting via the standby switch or the Windows operating system.
The Service LED on the front of the K2 Summit Client also indicates power supply
status. Refer to
“Service LED” on page 36 .
If the power source and the power cord are OK and the status lights on the power
supply indicate a problem, refer to
“Power supply problems” on page 82 .
LED LED state Status Condition
Green Green On The adapter is connected to a valid link partner
Green flashing Data activity
Off No link
Green/Yellow/
Orange Off 10 Mbps
Green 100 Mbps
Yellow 10000 Mbps
Orange flashing Identify
LED LED state Status Condition
OK Green On The power supply is operating normally
Fault Yellow On There is a power supply fault
~AC Green On The electrical current available to the power
supply meets power supply requirements. Input >
85 VAC.
1
!
OK
~AC
OK ~AC Fault