Grass Valley K2 Summit Client Service Manual Nov.23 2009 - Manual (Page 69)

12 October 2009 K2 Summit Production Client Service Manual 69
Using CompactFlash boot media for system restore
14. Select No, I do not and then click Next .
The Restoration Options page opens.
15. Do not change any settings on this page. Click Next .
The “…ready to proceed…” page opens.
16. Click Proceed .
The Operation Progress page opens and displays progress.
17. When a “The data was successfully restored” message appears, click OK .
18. Click Operations | Exit to exit the Acronis True Image program.
The K2 Summit Client restarts automatically.
19. Remove the Recovery Flash Drive while the K2 Summit Client is shutting down.
20. After restart, check the adapter names and order. Refer to “Reorder adapters” on
page 61 . If adapter names and order are not as documented, restore network
configuration, as directed in “Restoring network configuration” on page 53 .
Using CompactFlash boot media for system restore
This procedure applies to the CompactFlash card from which the K2 product normally
boots. If desired, you can prepare a second CompactFlash boot media for restoring
your K2 Summit Client, as follows:
1. For each K2 Summit Client, procure a blank CompactFlash boot media from Grass
Valley. You must use the CompactFlash media supplied by Grass Valley. Do not
use CompactFlash media procured elsewhere.
2. Label or otherwise identify the blank CompactFlash media with the name of the K2
Summit Client it restores.
3. If you have not already done so, use the USB Recovery Flash Drive and create a
recovery image of the K2 Summit Client.
4. Prepare to restore the K2 Summit Client by booting from the USB Recovery Flash
Drive. When the K2 Summit Client boots, do not proceed with the recovery
procedure.
5. Remove the CompactFlash boot media from the K2 Summit Client.
If the USB Recovery Flash Drive is in the USB port on the front bezel assembly,
you can remove the front bezel assembly to access the CompactFlash boot media.
Doing so does not disrupt the Acronis True Image program.
6. Insert the blank CompactFlash boot media into the K2 Summit Client.
7. Restore the image to the blank CompactFlash boot media.
This is now the Recovery CompactFlash boot media for that particular K2 Summit
Client.
8. Remove the Recovery CompactFlash boot media from the K2 Summit Client.
9. Insert the original CompactFlash boot media into the K2 Summit Client.
10. Click Operations | Exit to exit the Acronis True Image program.