Grass Valley 3-CCD CameraMan - Manual (Page 98)

98 CameraMan Installation and Operation Manual
Appendix K — CPT-2018-A3DSP On-Screen Menus
Sharpness (DTL) Setting
Figure 70. Sharpness (DTL) Setting Submenu
Other Settings
Figure 71. Other Settings Submenu
Table 42. Sharpness (DTL) Settings
DTL Select (Normal, Super DTL) If contour correction is not sufficient at the
Normal position when Detail Level setting is set to Low or High,
select the Super DTL position.
Level (OFF, Low, High) Detail level can be adjusted when Detail Select
setting is at Normal. Super DTL level can be adjusted when it is at
Super DTL.
Noise Suppress (OFF, Low, High) Screen noise can be reduced when Detail Level
setting is at High or Low.
Flesh Noise Suppress (OFF, Low, High) Flesh noise is suppressed in two steps when the
DTL Level is at High or Low.
Table 43. Other Settings
Shutter Speed 1/120, 1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/10000: Electronic shutter operates at one of these
speeds as selected.
S/Scan (Synchro Scan): Electronic shutter operates at the speed set with the electronic shutter syn-
chro-scan setting.
Auto ND: Electronic shutter is controlled to automatically adjust to luminance. (ELC)
Synchro Scan (50.40Hz to 15.63kHz) This setting is possible only when Electronic Shutter setting is at S/Scan.
Horizontal bar noise can be reduced by synchro-scan adjustment in shooting workstation scenes, for
example.
*For luminance settings at each shutter speed and synchro-scan shutter speed, refer to the following
table.